HomeMy WebLinkAbout6260 EL CAMINO REAL; ; AS080068; Permit12/27/24, 12:36 PM AS080068 Permit Data
City of Carlsbad
Sprinkler Permit
6260 EL CAM INO
Job Address:
REAL
Permit Type: SPRINK
Parcel No: 2131100100
Lot #: 0
Reference No.:.
Permit No: AS080068
Status: ISSUED
Applied 4/29/2008
Approved: 4/29/2008
Issued: 4/29/2008
PC #: Inspector:
Project Title: TRICITY WELLNESS BLDG. B THREE FIRE SPRINKLER
INSPECTIONS @ $65/EA
Applicant:
MILLENNIUM FIRE PROTECTION
SUITE F
101 COPPERWOOD WY
OCEANSIDE, CA
760-722-2722
Owner:
ECR CORPORATE CENTER LP
C/O MONICA R BROWNING
5600 AVENIDA ENCINAS #100
CARLSBAD CA
Fees ($) Add'l Fees ($) Total ($) Balance ($)
195 0 195 0
about:blank
THERE ARE NO
PLANS
ASSOCIATED WITH
THIS PERMIT
&uo
Contractor's Material and Test Certificate for Aboveground piping
PROCEDURE
Upon completion of work inspection and tests shall be made by the contractors representative and witnessed by an owners
representative. All defects shall be corrected and system left in service before contractors personnel finally leave the job.
A certificate shall be filled out and signed by both representatives. Copies shall be prepared for approving authorities, owners and contractor.
It is understood the owners representatives signature in no way prejudices any claim against contractor for faulty material, poor workmanship,
or failure to comply with approving authority's requirements or local ordinances.
PROPERTY NAME: Tr-City Wellness Center TI 1DATE:
PROPERTY ADDRESS: 6260 El,Camino Real, Carlsbad, CA
PLANS
ACCEPTED BY APPROVING AUTHORITIES (NAMES):
Carlsbad Fire Prevention
ADDRESS:
INSTALLATION CONFORMS TO ACCEPTED PLANS Li YES LINO EQUIPMENT USED IS APPROVED
. Li YES Li NO IF NO, EXPLAIN DEVIATIONS:
INSTRUCTIONS
HAS PERSON IN CHARGE OF FIRE EQUIPMENT BEEN INSTRUCTED AS TO LOCATION
OF CONTROL VALVES AND CARE AND MAINTENANCE OF THIS NEW EQUIPMENT? Li YES FIND IF NO, EXPLAIN
HAVE COPIES OF THE FOLLOWING BEEN LEFT ON THE PREMISES: Li YES Li NO
SYSTEM COMPONENTS INSTRUCTIONS Li YES Li NO
CARE AND MAINTENANCE INSTRUCTIONS LII YES Li NO
NFPA25 LIJYES LINO LOCATION
OF SYSTEM
SUPPLIES BUILDINGS:
New Office Area
MAKE MODEL
YEAR OF
MANUFACTURI
. ORIFICE
SIZE QUANTITY
TEMPERATURE
RATING Reliable FIFR 2010 1/2" 88 155
SPRINKLERS
PIPE AND
FITTINGS
Type of Pipe: Sch 40, Dyna-thread
Type of Fitting: Ci/Di Threaded
ALARM
VALVE
OR FLOW
INDICATOR
ALARM DEVICE
MAXIMUM TIME TO OPERATE
THROUGH TEST CONNECTION
TYPE MAKE MODEL MIN SEC Flow Switch Potter Elec. VSR
.
DRY PIPE
OPERATING
TEST
DRY VALVE Q.O.D. MODEL SERIAL NO. MAKE MODEL SEJAtNO.
TIME TO TRIP
THROUGH TEST
CONNECTION
WTER
PRESS tR
AIR
PRESSURE
TRIP POINT
AIR FIRES 3
TIMffiWTER
-1EACHED
TEST OUTLET
ALARM
OPERATED
PROPERLY
MIN SEC PSI -f'Sl MIN SEC YES NO Without
Q.O.D.
With
Q.OD.
IXPLAIN
H PNEUMATIC H ELECTRIC H HYDULIC
PIPING SUPERVISED ----LJES H NO DETECTING MEDIA SUPERVISO—EYES H NO DOES VALVE OPERATE FROM THE MTALjIP AND/OR REMOTE CONTROL SADN EYES FIND DELUGE AND IS THERE AN ACCESSIBLE FACILITY IN EACH CIR R TESTING IF NO, EXPLAIN
PR EACTIO N
VALVES LI YES
DOESH-C1CUlT OPERATE I DOES EACH C RCU MAXIMUM TIME TO
MAKE MODEL tJRVISION LOSS ALARM? OPERATE VALVE RELEASE? ERATE RELEASE
YES NO YES NO MI 'R— SEC.
PRESSURE LOCATIO SETTING STATIC PRESSURE RESIDUAL PRESSUR E
REDUCING & FLOOR MODEL WING)
VALVE TEST I) I OUTLET OUTLET (PSI) FLOW (GPM)
HYDROSTATIC: Hydrostatic tests shall be made at not less than 200 psi (13.6 bars) for two hours or 50 pai (3.4 bars) above
TEST static pressure in excess of 150 psi (10.2 bars) for two hours. Differential dry-pipe valve clappers shall be left open during
DESCRIPTION test to prevent damage. All abovegroung piping leakage shall be stopped.
PNEUMATIC: Establish 40 psi (2.7 bars) air pressure and measure drop which shall not exceed 1-1/2 psi (.01 bars) in 24 hours.
Test pressure tanks at normal water level and air pressure and measure air pressure drop which shall not exceed
1-1/2 psi (0.1 bars) in 24 hours.
IF NO, STATE REASON ALL PIPING HYDROSTATICALLY TESTED AT 200 PSI FOR 2 HRSJ
DRY PIPING PNEUMATICALLY TESTED H YES H NO n/a
EQUIPMENT OPERATES PROPERLY EYES LI NO
DO YOU CERTIFY AS THE SPRINKLER CONTRACTOR THAT ADDITIVES AND CORROSIVE CHEMICALS, SODIUM SILICATE OR
DERIVATIVES OF SODIUM SILICATE, BRINE, OR OTHER CORROSIVE CHEMICALS WERE NOT USED FOR TESTING SYSTEMS
TEST OR STOPPING LEAKS? H YES H NO
DRAIN READING OF GAGE LOCATED NEAR WATER. RESIDUAL PRESSURE WITH VALVE IN TEST
TEST SUPPLY TEST CONNECTION: PSI CONNECTION OPEN WIDE _ PSI
UNDERGROUND MAINS AND LEAD IN CONECTIONS TO SYSTEM RISERS FLUSHED BEFORE CONNECTION MAKE
TO SPRINKLER PIPING.
VERIFIED BY COPY OF THE U FORM NO. 85B EYES H NO OTHER EXPLAIN FLUSHED BY INSTALLER OF UNDER- Existing System
GROUND SPRINKLER PIPING EYES H NO
IF POWDER-DRIVEN FASTENERS ARE USED IN CONCRETE, HAS REP- . IF NO, EXPLAIN
RESENTATIVE SAMPLE TESTING BEEN SATISFACTORILY COMPLETED? EYES H NO N/A BLANK TESTING NUMBER USED LOCATIONS NUMBER REMOVED
GASKETS
WELDED PIPING H YES H NO
IF YES...
DO YOU CERTIFY AS THE SPRINKLER CONTRACTOR THAT WELDING PROCEDURES COMPLY
WITH THE REQUIREMENTS OF AT LEAST AWS D10.9, LEVEL AR-3?
. EYES H NO
DO YOU CERITIFY THAT THE WELDING WAS PREFORMED BY WELDERS QUALIFIED IN
WELDING COMPLIANCE WITH THE REQUIREMENTS OF AT LEAST AWS D1 0.9, LEVEL AR-3? EYES H NO DO YOU CERITIFY THAT WELDING WAS CARRIED OUT IN COMPLIANCE WITH A
DOCUMENTED QUALITY CONTROL PROCEDURE TO ENSURE THAT ALL DISCS ARE
RETRIEVED. THAT OPENINGS IN PIPING ARE SMOOTH. THAT SLAG AND OTHER
WELDING RESIDUE ARE REMOVED, AND THAT THE INTERNAL DIAMETERS OF
PIPING ARE NOT PENETRATED? EYES H NO
CUTOUTS DO YOU CERITIFY THE YOU HAVE A CONTROL FEATURE TO ENSURE THAT ALL
(DISCS) CUTOUTS (DISCS) ARE RETRIEVED? EYES Effo HYDRAULIC NAME PLATE PROVIDED IF NO, EXPLAIN
DATA Plate should be Existing
NAMEPLATE EYES H NO
DATE LEFT IN SERVICE WITH ALL CONTROL VALVES OPEN:
REMARKS
NAME 01- SPRINKLER CON I RAG ION
MILLENNIUM FIRE PROTECTION CORPORATION
TESTS WITNESSED BY
SIGNATURES FOR PROPERTY OWNER (SIGNED) TITLE DATE
FOR SPRINKLER CON ACTOR (SIGNED) TITLE , DATE - -
ADDITIONAL EXPLANT4ON AND NOTES